Engineering Guides
-
Precision Grinding RFQ: What to Specify for Size, Geometry, Surface Finish and Inspection
For a useful precision-grinding quotation, identify which surfaces need grinding, what each finished surface must meet, and which drawing revision governs the work. Include the part’s material and incoming condition, the required quantity, and any acceptance evidence the buyer needs. A note saying only “precision grind” or “fine finish” leaves the supplier to guess at…
-
Functional Fit Requirements for CNC Bushings and Locating Pins
A useful RFQ for a precision bushing or locating pin defines both sides of each important interface. Identify the part to be supplied, the mating hole or shaft, the required assembly function, and the drawing requirements that control size and alignment. A nominal diameter and the instruction “make it fit” leave essential decisions unresolved. This…
-
CNC Threaded Parts RFQ: Model, Thread Callouts, Effective Thread Depth and Mating Requirements
An accurate RFQ for a CNC threaded part defines the thread and the surrounding component as one functional specification. Send the controlled model or drawing, the complete thread requirement, usable threaded length, hole geometry and mating-part information—not just a nominal hole size. This is especially important for precision bushings, pins, sleeves and fixture components. A…
-
Replacing Straight and Key-Groove Punches: Interface Checks Before Ordering
A replacement punch must match more than the cutting profile and overall length. If the existing holder, fixing key or guide will remain, confirm how the punch is located, retained and oriented, and which faces control its installed position. This matters when an enquiry describes a “straight carbide punch” or a “punch with a key…
-
Replacement Guide Posts and Bushings: Selection and Compatibility Review
To select a replacement guide post or bushing, match the retained mating component and mounting arrangement before approving the new part. A nominal diameter or familiar part number is useful identification, but it is not a complete compatibility specification. The practical starting point is a simple question: What will be replaced, and what will remain…
-
Why Precision Punches Chip, Gall or Wear Prematurely
A damaged punch is a starting point for review, not a diagnosis. Before ordering a different steel or coating, describe the damage, identify when it began and collect information about the punch, mating die and workpiece. A useful replacement enquiry separates two questions: What must the new component reproduce, and what application conditions need review…
-
SKD11 vs SKH51 for Precision Punches: Material Selection Guide
A practical material-selection guide comparing SKD11/D2 and SKH51/M2/HSS for precision punches by wear, geometry, heat treatment and failure mode.
-
Independent Guide Post Sets vs Die Set Guide Posts: How to Choose
A practical comparison of independent guide post sets, die set guide posts and stripper guides, including selection boundaries, interfaces and RFQ data.
-
How to Source Precision Punches: Standard, Custom, and Carbide Options
A sourcing guide to standard, custom and carbide punches, including SKD11/D2, SKH51/M2/HSS, wear modes, coatings, drawing review and RFQ preparation.
-
How to Choose Die Springs for Stamping Dies: Rectangular, Coil, and Nitrogen Gas Springs
A practical engineering guide to comparing rectangular die springs, round-wire coil springs and nitrogen gas springs by force, travel, installation envelope and sourcing requirements.